al
no_unload_plate_sensor
nups
Platesetter_3244
Disables optical plate sensor on the unload table. There are two sensors on one
board, the upper one is known as the unload_queued sensor and the lower one
is
known as the unloading_plate sensor. Both feed into the LUE board.
nups = 0 enables checking of both sensors.nups = 1 disables checking of both sensors.
integer
0
0 to 1
When unloading a plate from the drum, the firmware allows (sensor_delay)
milliseconds
for leading edge of the plate to get between sensors , that is unloading_plate
covered
and unload_queued not covered, if nups=0 (enabled). If nups=1 then no checking
is done.
cal